Maximum efficiency and waterproofĀ system
Catalogue - SANECORĀ® PVC sewage system
adequa SANECORĀ® corrugated PVC sewage system is the solution of maximum efficiency for sewage systemsĀ used in urban sewer systems, rainwater collectors, interceptor collectors, emissaries, drains and, in general, pipes for transporting water and other liquids by gravity (industrial pipes, replacement of irrigation ditches, etc), and in general, applications related to sanitation and waste water.
The main advantages of adequa Sanecor PVC sewage system are:
- Complete and totally sealed sewage system.
- Very high rigidity values to withstand external loads in the short and long term.
- Large interior diameters that guarantee optimum flow rates.
- Sustainable products that ensure maximum energy efficiency throughout their entire life cycle.
- Reliability and guarantee widely recognised in the marketplace.
Main advantages
Watertightness
Completely sealed sewage system
Rigidity
Very high rigidity values to withstand external loads
Hydraulic capacity
Large interior diameters that guarantee optimum flow rates
Sustainability
Long life cycle: made to last
Experience
More than 28 years of experience (65.000 km pipes installed)
Wide range
Pipes, fittings and manholes
100% recyclable
100% recyclable material
Range
PVC pipes with structured double layer wall, smooth inside and corrugated outside: nominal diameters (in mm) ND 160 ā ND 1200, in 6 and 3 m lengths. Nominal rigidity SN8 (ā„8 kN/m2).
Special PVC parts for the entire range of diameters: sleeves, elbows, branches, extensions and covers. SN8 corrugated parts in 630 ND to 1200 ND.
Connections using elastomer clips for the entire range of diameters, mechanical clips with elastic seal (160 ND and 200 ND in 315 collectors), and junctions stuck at 45Āŗ and 90Āŗ for collectors of up to 500 ND. Drilling cutters for 60, 200 and 250 ND are also included.
Prefabricated inspection manholes with ready-installed rungs in diameters 800, 1000 and 1200, and depths of up to 9 meters. Connectivity to the manifold can be made by direct connections to the body of the manhole, by means of a base that can be fitted to the key of the manifold, either straight or with a change of direction, and by means of connecting pieces with full bore. Manholes and inspection wells in 600 y 800 diameters are also included.
It is also possible to manufacture a wide range of customized traps and manholes for multiple applications: sample connections, grease separators, siphon traps, manholes, etc.
VĆdeos
